P2714
PPowertrainPressure Control Solenoid D Performance/Stuck Off
What does this code mean?
Severity : HighP2714 indicates a performance problem with automatic transmission pressure control solenoid D, or the solenoid is stuck off. This solenoid controls hydraulic pressure to an internal clutch or brake. The transmission control module sees that the expected gear is not being achieved correctly.
Symptoms
- Check engine or transmission warning light on.
- Harsh or delayed shifts.
- Transmission slipping.
- Transmission stuck in one gear in limp mode.
- Higher fuel consumption.
Possible causes
- Low or degraded transmission fluid.
- Sticking or faulty pressure control solenoid D.
- Dirty or worn valve body.
- Damaged transmission wiring or connector.
- Internal transmission wear.
Diagnosis and repair
- Check transmission fluid level and condition using the manufacturer method.
- Read transmission codes and watch live data during a test drive.
- Inspect the transmission connector and wiring.
- Test the solenoid with a multimeter or through the scan tool.
- Replace the solenoid or service the valve body, then clear the code and run adaptations.
Is this vehicle in your workshop?
Upload the ORI file: it is processed automatically in a few minutes, 24/7, and a calibration engineer takes over complex cases during opening hours.
Are you a driver?
Find a garage or a diagnostics and remapping specialist near you.
Find a pro on ChiptuneMAPCode details
Code
P2714
Category
Powertrain
Prefix
P
Standard
OBD-II / SAE J2012